Re: [PATCH v4] iio: adc: ad7192: replace usleep_range() with fsleep()

[Andy Shevchenko]

On Mon, May 11, 2026 at 07:55:44AM +0500, Stepan Ionichev wrote:
> The AD7192 datasheet (Rev. A, page 34, RESET section) says:
> "When a reset is initiated, the user must allow a period of
> 500 us before accessing any of the on-chip registers."

> Use fsleep(500) instead of usleep_range(500, 1000). The 500 us
> minimum stays the same; fsleep() picks the upper slack itself
> (about +25% on a default config).

The second sentence here...

> Add a code comment with the datasheet reference so the "why"
> of the wait is visible at the call site.

...and this paragraph are unneeded details.

Reviewed-by: Andy Shevchenko <andriy.shevchenko@xxxxxxxxx>

-- 
With Best Regards,
Andy Shevchenko