[PATCH v8 4/4] arm64: dts: amlogic: t7: khadas-vim4: enable the ethernet port

From: Lucas Tanure

Date: Sat Nov 21 2026 - 16:31:46 EST


The board carries a Realtek RTL8211F gigabit PHY on the external
management bus, connected to the MAC over RGMII. Its address pins
strap it to 1; it also answers on 0, the RTL8211F broadcast address,
so the vendor tree lists 0.

Enable the controller and the management bus multiplexer, hand the
controller the ethernet pins and point it at the PHY. RGMII needs a
delay on each of its two clocks. The board traces add none, so the PHY
adds both, which is what rgmii-id asks of it.

The PHY interrupt is on GPIOH_6, so link changes are reported, not
polled. The reset is an RC network on the board, not a SoC pin: no
reset line.

Signed-off-by: Lucas Tanure <tanure@xxxxxxxxx>
---
.../amlogic/amlogic-t7-a311d2-khadas-vim4.dts | 23 +++++++++++++++++++
1 file changed, 23 insertions(+)

diff --git a/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts b/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts
index 0fa83362b417..7b86ab2579aa 100644
--- a/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts
+++ b/arch/arm64/boot/dts/amlogic/amlogic-t7-a311d2-khadas-vim4.dts
@@ -14,6 +14,7 @@
compatible = "khadas,vim4", "amlogic,a311d2", "amlogic,t7";

aliases {
+ ethernet0 = &ethmac;
serial0 = &uart_a;
mmc0 = &sd_emmc_c;
mmc1 = &sd_emmc_b;
@@ -256,6 +257,28 @@
};
};

+&ethmac {
+ status = "okay";
+ pinctrl-0 = <&eth_pins>, <&eth_rgmii_pins>;
+ pinctrl-names = "default";
+ phy-mode = "rgmii-id";
+ phy-handle = <&external_phy>;
+};
+
+&eth_phy {
+ status = "okay";
+};
+
+&ext_mdio {
+ external_phy: ethernet-phy@1 {
+ /* Realtek RTL8211FD-CG */
+ reg = <1>;
+
+ interrupt-parent = <&gpio_intc>;
+ interrupts = <GPIOH_6 IRQ_TYPE_LEVEL_LOW>;
+ };
+};
+
&i2c_m_ao_a {
status = "okay";
pinctrl-0 = <&i2c0_ao_d_pins>;
--
2.56.1