Re: [PATCH] Bluetooth: hci_qca: Reset the in-band sleep state on power off

[Birk Skyum]

Hi Vladyslav,

On Wed, 14 Oct 2026 19:20:24 +0300, Vladyslav Tymoshchuk wrote:
> Would you fold this into a v2? I am happy to test it on this board and
> give my Tested-by there.

Yes, and thanks for the second trigger and the numbers.

I ran your quick power cycle on the Yoga Slim 7x (WCN7850) with
v7.3-rc7, ten cycles per module, power on 1 s after the power off and a
scan after each. All of them pass here, with the stock module too, so
this board does not show the failure. It does show the stale state.
Right after the power off, debugfs reads tx_ibs_state=2 and
rx_ibs_state=1 with the stock module, and 0 and 0 with v1 and with your
version. Your version also builds without warnings (W=1) on today's
bluetooth-next.

v2 takes your code, describes the AWAKE trigger next to the WAKING one,
and carries Fixes: 3e4be65eb82c and Cc: stable. The code is yours, so I
will add you as Co-developed-by, which needs your Signed-off-by. Reply
with it and it goes in above mine.

Birk