Re: [PATCH v3 2/2] media: qcom: camss: Enable the streams API on SC7280

[Hitesh Patel]

On 12/10/2026 10:27, Gjorgji Rosikopulos (Consultant) wrote:
> Thanks i will try to include your changes in my next series,
> it will need verification from your side as well.

Please do carry it in v2 - that is the right way round, since the patch
does not build without your series and there is no point in it going
separately.

Two things to make v2 easier:

1) streams_enable at SoC level, per Bryan's comment. struct camss_resources
   already has legacy_phy set once per SoC, so putting streams_enable
   next to it keeps the two consistent and drops the 15 per-subdev
   assignments my patch was adding. Happy to prepare that hunk if useful.

2) The CSIPHY legacy-PHY conflict Bryan reported on 1/8 yesterday. I
   already resolved that when porting to qcom-next v7.2; details in my
   reply on that thread. Reusing it should let v2 apply to current
   linux-next without you needing the hardware to test the legacy path.

The SER/DES setup is up and running here, so send v2 whenever it is ready
and I will verify on RB3 Gen2 (QCS6490 / SC7280) with two GMSL cameras
behind a MAX9296A, one per CSI-2 port. I will run it against current
linux-next rather than our vendor branch this time, so the Tested-by
applies to the tree you are actually submitting against.

---
Hitesh