Re: [PATCH v2 2/2] thermal: qcom: tsens: Disable wakeup interrupt setup on automotive targets

[Daniel Lezcano]

On 6/3/26 14:25, Konrad Dybcio wrote:
> On 01-Jun-26 08:37, Priyansh Jain wrote:
> > Add a no_irq_wake flag to struct tsens_plat_data to allow platforms
> > to control whether TSENS interrupts should be configured as wakeup
> > sources.
> >
> > Create a new data_automotive structure and add compatible strings for
> > automotive TSENS variants (SA8775P, SA8255P) with wakeup interrupts
> > disabled.
> >
> > Automotive platforms can enter a low-power parking suspend state where the
> > application processors and thermal mitigation paths are not active. In this
> > state, waking the system due to TSENS threshold interrupts does not enable
> > useful thermal action, but it does repeatedly break suspend residency and
> > increase battery drain.
> >
> > Allow these automotive variants to keep TSENS monitoring enabled during
> > normal runtime while opting out of TSENS wakeup interrupts during suspend,
> > so the system can remain in low power until ignition/resume.
>
> Can you not just disable the wakeup source via sysfs for
> your needs?

AFAIU, the system will crash for this version, so it has to be disabled