Re: [PATCH v3] usb: dwc3: qcom: Modify interrupt handling for eUSB2 Phy targets

[Konrad Dybcio]

On 5/13/26 10:48 PM, Dmitry Baryshkov wrote:
> On Mon, May 11, 2026 at 03:14:22PM +0530, Krishna Kurapati wrote:
>> eUSB2 targets handle wakeup interrupts differently depending on device
>> speed when operating in host mode.
>>
>> According to the eUSB2 specification, remote wakeup signaling in host
>> mode is detected via different data-line assertions based on the
>> connected device speed.
>>
>> When a low-speed device is connected, the host repeater drives eD+ to
>> logic '1' upon detecting a K-state on the USB lines during remote wakeup
>> (eUSB2 specification, Section 5.5.14).
>>
>> When a full-speed or high-speed device is connected, the host repeater
>> drives eD- to logic '1' upon detecting a K-state on the USB line during
>> remote wakeup (eUSB2 specification, Sections 5.5.15 and 5.5.18).
>>
>> Since the eUSB2 PHY's "DP" and "DM" interrupt lines monitor the eD+ and
>> eD- line states, configure the wakeup interrupts accordingly
>>
>> Signed-off-by: Krishna Kurapati <krishna.kurapati@xxxxxxxxxxxxxxxx>
>> ---

[...]

>> +	{
>> +		.compatible = "qcom,x1e80100-dwc3-mp",
>> +		.data = &dwc3_qcom_glymur_pdata,
> 
> This would result in the list of the platforms keeping on growing.
> Would you mind instead detecting eUSB2 by checking that HS PHY has its
> own phys property?

I think we've had a very similar issue on some other patch.. we could
use phy_mode, but it'd require first fixing this mess:

28:     PHY_MODE_USB_HOST,
29:     PHY_MODE_USB_HOST_LS,
30:     PHY_MODE_USB_HOST_FS,
31:     PHY_MODE_USB_HOST_HS,
32:     PHY_MODE_USB_HOST_SS,
33:     PHY_MODE_USB_DEVICE,
34:     PHY_MODE_USB_DEVICE_LS,
35:     PHY_MODE_USB_DEVICE_FS,
36:     PHY_MODE_USB_DEVICE_HS,
37:     PHY_MODE_USB_DEVICE_SS,
38:     PHY_MODE_USB_OTG

into PHY_MODE_USB + submodes and phy_opts

Konrad