Re: [PATCH v3 3/3] arm64: dts: qcom: eliza-mtp: Enable USB and ADSP support

[Abel Vesa]

On 26-05-13 01:04:12, Dmitry Baryshkov wrote:
> On Tue, May 12, 2026 at 03:26:49PM +0300, Abel Vesa wrote:
> > The Eliza MTP features a single USB Type-C port. Its USB 2.0 lines are
> > routed through an eUSB2 repeater provided by the PM7750BA PMIC.
> > 
> > Describe the port and repeater, and enable the USB controller and PHYs.
> > 
> > Also specify the ADSP firmware and enable the remoteproc.
> > 
> > Reviewed-by: Konrad Dybcio <konrad.dybcio@xxxxxxxxxxxxxxxx>
> > Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxxxxxxxx>
> > Tested-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxxxxxxxx>
> > Signed-off-by: Abel Vesa <abel.vesa@xxxxxxxxxxxxxxxx>
> > ---
> >  arch/arm64/boot/dts/qcom/eliza-mtp.dts | 81 ++++++++++++++++++++++++++++++++++
> >  1 file changed, 81 insertions(+)
> > 
> > +
> > +		connector@0 {
> > +			compatible = "usb-c-connector";
> > +			reg = <0>;
> > +
> > +			power-role = "dual";
> > +			data-role = "dual";
> > +
> > +			ports {
> > +				#address-cells = <1>;
> > +				#size-cells = <0>;
> > +
> > +				port@0 {
> > +					reg = <0>;
> > +
> > +					pmic_glink_hs_in: endpoint {
> > +						remote-endpoint = <&usb_dwc3_hs>;
> > +					};
> > +				};
> > +
> > +				port@1 {
> > +					reg = <1>;
> > +
> > +					pmic_glink_ss_in: endpoint {
> > +						remote-endpoint = <&usb_dp_qmpphy_out>;
> 
> No redrivers?

It will come with the DP support.