Re: [PATCH v4 03/12] arm64: dts: qcom: hamoa-pmic: Enable BCL sensor node

[Konrad Dybcio]

On 10/5/26 2:24 PM, Manaf Meethalavalappu Pallikunhi wrote:
> Add Battery Current Limiting (BCL) hardware monitor node for
> hamoa-pmic. The BCL monitors battery voltage and current, providing
> hardware interrupts when configurable thresholds are violated.
> 
> Reviewed-by: Abel Vesa <abel.vesa@xxxxxxxxxxxxxxxx>
> Signed-off-by: Manaf Meethalavalappu Pallikunhi <manaf.pallikunhi@xxxxxxxxxxxxxxxx>
> ---

[...]

> @@ -674,6 +685,17 @@ smb2360_0: pmic@7 {
>  
>  		status = "disabled";
>  
> +		sensor@4700 {

Is it not there on the 4 other SMB2360s?

Konrad

> +			compatible = "qcom,smb2360-bcl";
> +			reg = <0x4700>;
> +			interrupts = <0x7 0x47 0x0 IRQ_TYPE_EDGE_RISING>,
> +				     <0x7 0x47 0x1 IRQ_TYPE_EDGE_RISING>,
> +				     <0x7 0x47 0x2 IRQ_TYPE_EDGE_RISING>;
> +			interrupt-names = "max-min",
> +					  "critical",
> +					  "emergency";
> +		};
> +
>  		smb2360_0_eusb2_repeater: phy@fd00 {
>  			compatible = "qcom,smb2360-eusb2-repeater";
>  			reg = <0xfd00>;
>