Re: [Q] zynqmp-ipi-mailbox and SGI interrupts

[Sebastian Andrzej Siewior]

On 2026-10-16 11:44:07 [-0500], Shah, Tanmay wrote:
> > And it has to be a per-CPU interrupt? It can't become a regular
> > interrupt which is not per-CPU? Does the driver at some point access
> > per-CPU registers?
> > 
> 
> As per my understanding, it has to be a per-CPU interrupt.

I see.

> Driver access those registers via percpu APIs, for example:
> xlnx_mbox_cpuhp_start() uses enable_percpu_irq(). It is called for each CPU.

Yes I know that part but this is not the question.

I meant _why_ the interrupt has to be per-CPU. I'm not sure if this is
internal wired as such or just configured.

For instance a timer is using a per-CPU interrupt. While the timer is
programmed for the next expiry it uses per-CPU registers. So the timer
accessed from CPU0 is different than the one accessed from CPU1. Once
the interrupt fires, the processing that follows is different on both
CPUs.

Looking through zynqmp_sgi_interrupt() which just invokes
zynqmp_ipi_interrupt() I don't see the difference. The OP-TEE firmware
is invoked at least the bits I saw, it just masks the source and moves
on. So I am not sure what is the difference between the interrupt on
CPU0 vs CPU1. Both could fire at the same time and handle the same
request unless the firmware returns a different
IPI_MB_STATUS_RECV_PENDING bit. I don't see how the remote side would
make a difference between those two CPUs.

So this is what I am wondering about. Based on your response so far this
has to be that way.

> >> Thank you,
> >> Tanmay

Sebastian