[PATCH v3 5/6] phy: qcom-mipi-csi2: Use fsleep() for init sequence delays

[George Neacsu via B4 Relay]

From: George Neacsu <geocausa@xxxxxxxxx>

The init sequence delays are applied with udelay(), which busy-waits.
That is fine for the 1 us delays in the current D-PHY sequence, but the
X1E80100 C-PHY sequence added next waits about 3 ms after its reset
exit, and busy-waiting that long is wasteful. The sequence is written
from phy_power_on(), in process context, where sleeping is allowed; the
PHY reset just before it already uses usleep_range().

Switch to fsleep(). It still uses udelay() for delays of 10 us or less,
so the existing D-PHY sequence behaves as before.

Suggested-by: Nihal Kumar Gupta <nihal.gupta@xxxxxxxxxxxxxxxx>
Assisted-by: Claude:claude-opus-5-5
Signed-off-by: George Neacsu <geocausa@xxxxxxxxx>
---
 drivers/phy/qualcomm/phy-qcom-mipi-csi2-3ph-dphy.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/phy/qualcomm/phy-qcom-mipi-csi2-3ph-dphy.c b/drivers/phy/qualcomm/phy-qcom-mipi-csi2-3ph-dphy.c
index a44e104301..84c45f67fd 100644
--- a/drivers/phy/qualcomm/phy-qcom-mipi-csi2-3ph-dphy.c
+++ b/drivers/phy/qualcomm/phy-qcom-mipi-csi2-3ph-dphy.c
@@ -264,7 +264,7 @@ phy_qcom_mipi_csi2_gen2_config_lanes(struct mipi_csi2phy_device *csi2phy,
 		}
 		writel(val, csi2phy->base + r->reg_addr);
 		if (r->delay_us)
-			udelay(r->delay_us);
+			fsleep(r->delay_us);
 	}
 }
 

-- 
2.53.0