Re: [PATCH RFC v2 4/4] phy: qcom-mipi-csi2: Add C-PHY support for X1E80100

[Nihal Kumar Gupta]

On 16-10-2026 16:27, George Neacsu via B4 Relay wrote:
> +	{.reg_addr = 0x0a54, .reg_data = 0x00, .param_type = CSIPHY_DEFAULT_PARAMS},
> +	{.reg_addr = 0x0a40, .reg_data = 0x00, .param_type = CSIPHY_DEFAULT_PARAMS},
> +	{.reg_addr = 0x0a60, .reg_data = 0xa8, .param_type = CSIPHY_DEFAULT_PARAMS},
> +	{.reg_addr = 0x0a84, .reg_data = 0x00, .param_type = CSIPHY_DEFAULT_PARAMS},
> +	{.reg_addr = 0x0a90, .reg_data = 0x02, .param_type = CSIPHY_DEFAULT_PARAMS},
> +
> +	/* csiphy_reset_exit_reg_2_1_2, 3PH */
> +	{.reg_addr = 0x1000, .reg_data = 0x0e, .delay_us = 3048,
> +	 .param_type = CSIPHY_DEFAULT_PARAMS},
> +};
> +
I checked the register settings and they look good to me.

Can we write the delay value in hex as well, to keep the table
formatting consistent.
-- 
Regards,
Nihal Kumar Gupta